315Mhz DC12V 4CH Remote Control Switch RM06
Receiver Specifications
1) Supply Voltage 12V DC
2) Static Current =< 6mA
3) Frequency 433 MHz
4) Sensitivity >= -105 dB
5) Relay Spec. 10A, 120VAC / 10A, 24V DC
6) Operating Temperature -40 to 80 deg C
7) Dimension: 22x30x11mm
8) Weight (with housing) 2.5 oz
Transmitter (Remote) Specifications
1) Battery Voltage: 12V (1 piece)
2) Dimension: 15x25x5mm
3) Weight (with battery): 1.2 oz
4) Range: 20-100m
Application
Garage doors, appliances switches or other areas of wireless control
Load Type
Fluorescent energy saving lamp LED light load motor ...... etc.
Output
Relay common / normally open / normally closed
Four Control Channels :
A.Self-locking control mode : Click the button corresponding relay switches in the same key , click the
corresponding relay is switched off , ABCD four independently -off .
B.Jog type control mode : Long press buttons corresponding relay switches , release the button
corresponding to the relay is switched off , 4-way can not work independently , each only way to work ;
C.Interlocked control mode: Press the A button A and lock has been switched on, press the B button to
disconnect A , B and lock has been switched on, press the C key to disconnect the B, C Lu has been turned
ON and locked press the D key to disconnect C, D Road has been turned on and turned the lock , you can
only turn all the way , and as fans gear . )
Tips: Remote control buttons Press only one button can not hold down two or more keys simultaneously ,
otherwise it will affect the normal work of mutual interference .
D Learning code mode :
Click the button to learn , indicator lights , release the button to learn , within 15 seconds, press any button on the remote control , the receiver learn LED flash , remote control and receiver success of the code . after 15 seconds if no transmitter signal is input to learn,learn about LED flash , auto- exit learning state , supports up to 30 different remote control code
learning the code , when learning to 31 remote will automatically clear the first remote control
controller .
E.Clear the right code ;
Tight hold button and hold the receiver to learn , learning indicator
lights After about 8 seconds , until the learn indicator light goes out , release the learn button ,
remove all code learning remote control.
Payment Terms︰ tt,western union , paypal , Escrow,Cash
