Introduction
This is a contact-less proximity keypad access control reader , support EM, or mf proximity cards is one of the most advanced access control reader, using a unique design, smart panel operation, built-in high-end microprocessors, high anti-interference ability and high security and reliability, can provide strong security. It has ultra-low power, Wiegand output, easy to use, can be widely used in homes, offices, residential quarters and other public places.
Features
1) Low power consumption: standby current less than 50mA.
2) Wiegand output: support WG26 or WG34 in a same reader
3) Built-in buzzer.
Technical parameters
Work Voltage: DC12V±10％
Static Current: ≤50mA
Reading Range: 3～10cm
Ambient Temperature：-25℃～85℃
Ambient Humidity：10%～90%
Size：80*110*21mm
Using + type screw driver to loosen the screw between the panel and motherboard. And then embed the motherboard to the side wall with the plastic plug and screws.
Wire Connection
7 pins
Red DC 12V
Black GND
Green D0
White D1
Blue LED
Yellow Beep
Grey WG34 ( if you need wiegand 34 output , kindly connect the grey cable to GND)
2pins
Orange Door Bell
Purple Door Bell
Notice
1. Confirm the electric voltage (DC12V) and differentiate positive anode and cathode of power supply
2. When external Power is used, make sure sharing the power with Controller Box or using the same GND
3. When the distance between card reader and controller is more than 50m, please use Power Line with at least 1.5 square cm Dia, or using several parallel Network wire
